3–2 Central Section of Control Console Keyboard
The central section of the Control Console Keyboard is used to select and display the kV
and mAs values.
2 : . :5
D In AOP mode the readout displays the kV values selected by the system and the
mAs values output.
D At start of compression, the kV readout displays the code of the mode selected:
CNT, DOSE, and STD. The mAs readout displays the AUTO mode.
D At end of exposure, the kV readout displays the kV values selected. The kV
readout displays the first letter of the code of the selected mode (C, D, or S) and
the mAs readout displays the mAs values output.
D In AEC mode, the readout displays the kV values selected by the operator and
the mAs values output preceded by the letter A.
D In manual mode the readout displays the kV and mAs values selected by the
operator.
2 7
.! ;D (, ! ) ( " ;D ! ; ; <
(= 5 8"8 <! ! (= ! (,
! ;D < ;D ) ;D=
1 56/ # ! ; ! ""
. 7
.! 5 (, ) ! 5 ! ; ; 5
8"8 <! ! (= ! (, !
5 <) 5=
1 56/ 5&' # ! ; ! ""
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
