GE Universal Remote User Manual

6
Write your codes down here for easy reference
later.
Direct Code Entry
1. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
2. Press and release the desired device
button (TV, DVR, etc.). The red indicator
blinks, then stays lit.
3. Enter the 4-digit code
from the code tables
(on separate sheet).
Note: after a valid
code entry, the red
indicator turns off. For
an invalid code, the
red indicator ashes.
4. With your device on, press
ON/OFF.
If the device turns off, no further
programming is required. Note: If
some buttons do not operate your
equipment, try one of the other
codes for your brand.
Device Device stored Code
TV TV
CBL/SAT
DVD/DVR

GE Universal Remote Specifications

General

Backlit Keypad	No
Pre-programmed Codes	Yes
Learning Function	No
Device Compatibility	TVs, DVD players, Blu-ray players, audio systems, streaming devices
Number of Devices Supported	4
Programming Method	Auto Code Search