65
Copyright 2009
Heater Assembly
• The heater assembly is held in place by a bracket attached to the
outside of the outer tub and a 10-mm nut which compresses a rubber
gasket to the tub opening.
• When the 10-mm hex nut is tightened, it squeezes the rubber gasket
between 2 mounting plates to seal the heater assembly to the opening
of the tub.
• The hex nut is set from the factory at 35 - 40 in. lbs of torque.
• The wire terminal under hex nut is unused.
(Rear of Machine)
To Next Page
Loading...
