Beforeyoucall forservice...
Troubleshooting tips
Possible Causes What ToDo
Drain hose is kinked or
improperly connected
Fill hoses or drain hose is
improperly connected
Household drain may
be dogged
Constant water pressure
to the fill hoses at the
water source
- Straighten drain hose and
make sure washer is not
sitting on it.
*'Top of drain outlet should
be less than 8 ft. above
floor.
* Make sure hose
connection,; are light at
faucets ,and make sure end
of drain hose is correctly
inserted in and secured to
drain facility.
Check household
plumbing. You may need
to call a plumber,
Tighten hoses at the
faucets and turn the water
off after each use.
"; Check condiition of the fill
hoses; they mayneed
replacement after 5 years,
Washer is uneven
Washer load is
unbalanced
"Make sure vcasher is level
•and fwna to the floor.
" Push the Cycle knob in to
stop the washer, open the
lid and redistribute the
load evenly. Close the lid
and restart.
The washer normally pauses
between, washing steps
Incorrect cycle selected "Make sure the cycle
selected matches the load
you are washing.
/t
,a
To Next Page
Loading...
Need help?
General
