EasyManua.ls Logo

GE XL44 JGBP79 - Oven Usage and Maintenance

GE XL44 JGBP79
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
The shelves have stop-locks, so that when
placed correctly on the supports, they will
stop befin'e coming completely out, and
will not tilt.
\,\]_en placing and removing cookware,
pull the shelf out to the bump on the
shelf support.
To remove a shelf, pull it toward you,
flit the fl'ont end up and pull it out.
To replace, place the end of the shelf
(stop-locks) on the support, tilt up the
fl'ont and push the shelf in.
The oven has 5 shelf positions.
It also has a special low shelf
position (R)for roasting extra large
items, such as a large turke_
Plastic items on the cooktop may
melt if left too close to the venL
Oven Vent
Your oven is vented through ducts at the
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow of hot air fl'om the oven and
fl'esh air to the oven burner be
mfinterrupted. Avoid touclfing the vent
openings or nem4_y stu_i_ces durh_g oven or
broiler operation--they may become hot.
Handlesof potaandpansonthecooktopmay
becomehot if lefttoocloseto thevent
Donot/eaveplasticitemsonthecooktop--
theymaymeltif left toodoseto thevent
Donotleaveanyitemsonthecooktop.Thehot
ak fromtheventmayigniteflammableitemsand
wi//increasepressureindosedcontainers,which
maycausethemtoburst
Metalitemswill becomeveryhotif theyareleft
onthecooktop,andcouldcauseburns.
Power Outage for Electric Ignition Models
CAUTION: Do not makeanyattempt to operate the
electric ignition ovendunbg an electricalpower
failure.
The oven or broiler cannot be lit during a
power fifilure. Gas will not flow unless the
glow bar is hot.
If the oven is in use when a power fifilure
oCCtllN_the oven btlYneI" shuts off and
cannot be re-lit until power is restored. This
is because the flow (if gas is automaficallv
stopped and will not resume when power
is restored tmfil the glow bar has reached
operating temperature.
Oven Light
Use the switch (m the lower c(mtr(ll panel
to mrn the light on or off'.
18

Other manuals for GE XL44 JGBP79

Related product manuals