Beforeyoucall forservice...
Troubleshooting tips
Displaygoesblank
Possible Causes
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the * See' tile Special features of your oven control se(tion,
black-out mode.
Display flashes Power failure. * Reset tile dock.
Unableto get the Oven control pads were * Tile BAKE ;rod BROILHI/LO pads must be pressed at
display to show "SF" not pressed properly, tile same time and held fin" 3 see(rods,
Power outage, Power outage or surge. * Reset tile clock. If tile oveu was ill tlse vet! lUtlst l'eset
clock flashes it by, I)ressim_' _ the CLEAR/OFFpad,,settim_ the clock
and resetting any cooking flmction.
"Burning" or "oily" This is normal in a new oven * To speed the l)I'ocess, set a sellXcleau cycle f()l" ;I
odoremittingfrom and will disappear in time. minimum ot 3 hours. See tile Using the self-
the vent cleaning oven section.
Strongodor An odor from the insulation * This is teiill)Ol'al'y,
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise A cooling fan may • This is normal, The cooling tan will turn off and on,
automatically turn on mad
off to cool internal parts.
Drawer does not slide The drawer is out of afigmnent. * Fully extend the drawer and push it ;111tile way in.
smoothly or drags See tile Care and cleaning of the range sectiou.
Drawer is over-loaded or load * Reduce weight. Redistribute drawer contents.
is unbalanced.
Warming drawer will A fuse in your home may be * Replace tile fl/se (>r reset tile circuit breaker.
not work blown or the circuit breaker
tripped.
The oven is self-cleanh_g. * Wait for tile sell:clean cv('le to finish and the oven
to cool,
Controls improperly set. * See tile Electric warming drawersection.
Excessive condensation Liquid in warming drawer. * Remove liquid,
in the warming drawer
Uncovered foods. * Cover food with lid or aluminmn fi)il,
Temperature setting too high. * Reduce temperature settiu
Food dries out in the Moisture escaping. * Cover food with lid or almninmn foil,
warmingdrawer
What To Do
• Replace the filse or reset the circuit breaker:
5O
To Next Page
Loading...
