GEAppliances.com
Possible Causes What To Do
Oven will not self-clean The oven telnperatu_ is too • _dlow the l';lll*_e to cool to l'oonl [el//pel';ltul'e ;ind
high to set a self-clema operation, reset the controls.
Oven controls improperly set. * See the Usingtheself-cleaningoven section.
On models with a door latch, * Make sure you move the door latch handle ;ill the
the oven door is not in the way to tire right.
locked position.
"Crackling " or This is the sound of the * This is normal.
"popping" sound metal heating and cooling
during both the cooking mad
clemting functions.
Excessivesmoking Excessive soil. * Press tire CLEAR/OFFpad. Open tire windows to
rid tire room of smoke. _ait tmtil tire LOCKEDDOOR
light goes oil Wipe up tire excess soil and reset tire
clean cycle.
Oven door will not open Oven too hot. * Allow the oven to cool below locking temperatm'e.
after a clean cycle
Oven not clean after a Oven controls not properly set. * See the Using the self-cleaning oven se('ti_m.
clean cycle Oven was heavily soiled. * Clean up heavy spilh>vers before starting tire clean
cycle. Heavily soiled ovens may need to sell:clean
again or for a hmger period of time.
"LOCK O00R'flashes The self-cleml cycle has been * Close tire oven door.
in the display selected but the door is not
closed.
LOCKEDDOORlight
is on when youwant
to cook
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
• Press the CLEAR/OFFpad. Allow the o_en to cool,
and then, on models with a door latch, tmlock
the door.
"F--and a number or On models with a door latch, • The latch may have been moved, even if only slightly,
letter"flash in the display if a function error code appears from tire locked position. Make sure tire latch is moved
during the self-clemmag cycle, to the fight as liar as it will go.
check the oven door latch.
You have a flmction error code. • Press the CLEAR/OFFpad. Allow the oven to cool fin" one
houI: Put tire oven back into operation.
If the function code repeats. • Disconnect all power to tire range fl)r 5 minutes
and then reconnect power. If tire flmction error
code repeats, call fin" service.
Oven door willnot Oven is too hot. • ?dlow tire oven to cool below locking temperature.
unlock (on models with Do not lock the door with tire door latch except when
a doorlatch] using tire self:clean feature.
"Door" appears in the Self-clemfing cycle has been • Move tire latch handle all tire way to the right.
display (on models with selected but the latch handle
a door latch) was not moved all the way
to the right.
Latch handle was moved to • Move the latch handle to the right only when setting
the right but a program other the sell:cleaning cycle.
thml self-clemfing was selected.
49
To Next Page
Loading...
