GE ZISS480NXBSS

Design Guide
3/4" OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may
be installed on trimmed models. The overlay panel must
be secured to a 1/4" thick backer panel which slides
into the trim. A spacer panel 0.10" thick must be placed
between the overlay and backer panel.
Assemble the panels with glue and screws:
, Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
, Center the spacer and bucker panel on the overlay
panel and secure with glue and screws. Screws must
be countersunk into the backer panel.
Door
L
Backer .
Panel.......................Spacer
OverlaL
£ackerPanel
NOTE: Left-to-right offset is-
not nlwz_ys equn/ to top-to-
bottom off#eL
,250" + ,70" + ,750" - 7, 7OO" Tote# P_nel Thickness
IMPORTANTNOTE - DISPENSERMODELS
The refrigerator is supplied with two dispenser trims,
one for framed panels and one for overlay panels. The
overlay dispenser trim is designed to fit a total panel
thickness of 1.100".
, If the panel is less than !.100" a noticeable gap may
be created around the dispenser trim.
, If the panel is more than !.100" the dispenser trim
cannot be secured to the door.
See Dispenser Trim Fit Example, page 9.
, The overlay panel must be constructed according to
the specifications shown to achieve the correct total
thickness.
, Alternative panel construction methods such as
securing a 3/4" panel to a 1/4" backer panel cannot
be used. Another method, routing a 3/4" thick panel
on all sides, cannot be used. These methods will not
result in the required 1.100" panel thickness.
When a raised panel design is to be used, a custom
middle rail is required. See page 9 for details.
A
GrillePanel B
U
F
)ispen se L
Cutout
Freezer Fresh
Panel Food
Panel
-- m
_D_4 _E_
Dispenser Cutout
*Cut the dispenser opening after the backer, spacer and overlay
panels have been assembled,
IMPORTANT NOTE: Maximum total weight for the assembled
panels:
, Fresh food door panel - 75 Ibs.
Freezer door panel - 53 Ibs.
e Grille Panel- 18 Ibs.
36" Side-by-Side(ininches)
1/4" BackerPanel 33-7/8 9 68-3/8 14-9/16 18-9/16
.10"SpacerPanel 33 8-3/8 67 13-1/4 17-1/4
3/4" OverlayPanel 34-1/8 9-1/4 68-5/8 14-13/16 18-13/16
42" Side-by-Side(ininches)
1/4" BackerPanel 39-7/8 9-1/2 68-3/8 14-9/16 24-9/16
.10"SpacerPanel 39 8-5/8 67 13-1/4 23-1/4
3/4" OverlayPanel 40-1/8 9-3/4 68-5/8 14-13/16 24-13/16
48" Side-by-Side(ininches)
1/4" BackerPanel 45-7/8 9-1/2 68-3/8 18-9/16 26-9/16
.10"SpacerPanel 45 8-5/8 67 17-1/4 25-1/4
3/4" OverlayPanel 46-1/8 9-3/4 68-5/8 18-13/16 26-13/16