Geberit Bambini - User Manual

Questions and Answers

T
Tracy WilliamsJul 27, 2025
What to do if the Geberit Plumbing Product flush does not actuate?
- R
  Ryan MckinneyJul 27, 2025
  If the Geberit Plumbing Product flush does not actuate, there are several possible causes: * The pipe pressure may be too low, in which case you should test the pipe pressure (1–8.5 bar). * There may be a network failure; check the power supply. * The battery may be dead; replace the battery. * The solenoid valve may be defective; replace the solenoid valve. * The IR sensor may be defective; replace the IR sensor.
U
uallenAug 1, 2025
Why is the Geberit Bambini Plumbing Product water running continuously?
- J
  James WilsonAug 1, 2025
  If water runs continuously, it could be due to several reasons: * The solenoid valve may be defective, so replace it. * The IR sensor may be defective, so replace it. * The pipe pressure may be too high, so test the pipe pressure (1–8.5 bar).
B
Brittany DelgadoAug 5, 2025
What to do if Geberit Bambini water jet is too weak?
- K
  Kevin ChapmanAug 5, 2025
  If the water jet is too weak, consider the following: * The tap aerator might be dirty, so clean it. * The basket filter might be clogged, so clean it. * The pipe pressure might be too low, so test the pipe pressure (1–8.5 bar).
C
Christopher WaltersAug 9, 2025
Why does the Geberit Bambini LED light up, but the flush does not actuate?
- C
  Chloe PrestonAug 9, 2025
  If the LED lights up but the flush does not actuate, the battery is likely dead. Replace the battery.
S
Steven HammondAug 13, 2025
What to do if the Geberit Plumbing Product has an unwanted flow of water?
- M
  Michael SpencerAug 13, 2025
  If there's an unwanted flow of water (either too soon or delayed), consider these solutions: * The IR window might be dirty or wet; clean or dry the IR window. * The IR window might be scratched; contact a skilled person. * The detection distance of the IR sensor might not be set correctly; set the detection distance.
R
Ross LewisAug 18, 2025
Why is the red LED flashing during flush actuation on my Geberit Bambini?
- T
  Theresa JonesAug 18, 2025
  If the red LED flashes during flush actuation, it indicates that the battery is almost dead. Replace the battery.
C
collin95Aug 22, 2025
Why is water dripping from the tap housing of my Geberit Bambini Plumbing Product?
- H
  hdavidsonAug 22, 2025
  If water drips from the tap housing, the solenoid valve may not be closing properly. Clean or replace the solenoid valve.