Geberit ESG light - Operating the Electrofusion Tool; Electrofusion Welding Process; Operational Prerequisites

EN
Operation
Welding with the Geberit ESG
Light electrofusion tool
The Geberit ESG Light electrofusion
tool is equipped with an automatic
mechanism which prevents a double
weld when a coupling connection
cable is connected.
The required welding time is
adjusted automatically in accordance
with the ambient temperature.
Prerequisite
– Pipes, fittings and welding joints are dry
and free of dirt.
– Pipes and fittings are prepared in
accordance with the installation manual
for Geberit electrofusion sleeve
couplings.
– Pipe surfaces are prepared in
accordance with the installation manual
for Geberit electrofusion tape for anchor
point.
WARNING
Danger of death from electric
shock
▶ Do not weld wet or water-filled
pipes.
▶ An isolation transformer must
be included in the circuit when
carrying out electrofusion work
in damp areas.
CAUTION
Risk of injury from burns
▶ Do not touch the electrofusion
sleeve coupling or electro-
fusion tape, plug contacts and
pipe during the welding
procedure or during the
cooling-down phase.
ATTENTION
Leaking connection caused by faulty
welding
▶ The pipe to be welded must be kept in
a tension-free position during the
welding procedure and the cooling-
down phase.
▶ Air draughts through the pipe interior
must be avoided.
72057596303590795 © 11-2023
967.778.00.0(03)
23