Geberit ESG light - Cancelling Welding Operations; Troubleshooting and Malfunction Rectification

EN
Aborting the welding procedure
with Geberit ESG Light electro-
fusion tool
1 To cancel the welding procedure,
press the start button.

✓ Welding procedure LED display
goes out.
2 Unplug both sleeve connection plugs.

✓ Malfunction LED display
flashes.
3 Press the start button and hold for
three seconds.


✓ Malfunction LED display goes
out.
Result
✓ The welding procedure has been
aborted. Repeat the welding procedure
with the cooled Geberit electrofusion
coupling or the cooled Geberit electro-
fusion tape for anchor point.
Rectifying malfunctions
If the Malfunction LED display lights up or the Malfunction LED display plus another LED
display light up, the welding process has been aborted prematurely because of a malfunction.
Malfunction Cause Rectification
Malfunction and Mains
connection LED displays
light up.
Mains voltage too low. ▶ Switch off any non-essential
consumers.
Mains voltage too high. ▶ Disconnect the mains plug
and contact the power
supplier.
72057596303590795 © 11-2023
967.778.00.0(03)
25