EN
16
B249-005 © 12-2013
964.874.00.0 (04)
NOTE
Pressing jaws are wearing parts. Frequent pressing will cause the
material to become worn; advanced stages of wear will be
indicated by incipient cracks. Pressing jaws that display this kind of
wear or are damaged in any other way may break, particularly if
they are used incorrectly (e.g. pressing a fitting that is too large,
tilting, foreign bodies on the fitting) or in a way that does not comply
with their intended use.
General
• Do not continue to use the pressing jaws when they are worn
• Take pressing jaws displaying cracks out of service immediately
and do not continue to use them
• Use the transport case for transport and storage, and store the
pressing jaws in a dry room
• Observe the safety notes with respect to the cleaning and
corrosion-protection agents used
To Next Page
Loading...
