10
Channels to Store
You can turn off any unused channels to save storage space. Storing the vector sum is a
waste of space if you are already storing ENZ. Toggle the channels on or off as required.
The 3D Vector channel should not be enabled unless it is required for data if telemetry
bandwidth is limited. Note that if a channel is enabled for telemetry (see next setting
below), it will automatically be stored to the SD card to ensure the data is available for
backfill should the communication link drop out.
If all channels are accidentally turned off, the Z channel is automatically re-enabled to
ensure at least one channel is being recorded. Note that if a channel is turned off here, it
will also be turned off in the “Channels to Send” settings – see below.
Channels to Send
You can select which channels to send continuously to your remote server. For blast and
structural vibration monitoring applications you may choose to send the 3D Vector sum
channel continuously, storing the ENZO channels to be streamed only when a trigger
process detects an event.
Toggle the channels that you want to send continuously on or off using the Right button.
Note that if a channel is enabled for telemetry, it will automatically be turned on in the
“Channels to Store” settings as the stored data is required for backfilling gaps in data
telemetry. Disabling a channel in telemetry will not disable that channel in the “Channels to
Store” settings.
To Next Page
Loading...
