10
Preparation
Connections
The speakers and the subwoofer output terminals are
located on the 10-pin MATE-N-LOK connector marked
"SUB R-R R-L F-R F-L"
Remove the cover screws from the front of the apparatus
with a Phillips screw driver.
Remove cover and put aside the foam gaskets located in
the wire channel.
To prevent electric shock hazard, do not connect to main power supply while the cover is removed.
Connector pins Identification
1 Front Left speaker (+)
2 Front Left speaker (-)
3 Front Right speaker (-)
4 Front Right speaker (+)
5 Rear Left speaker (+)
6 Rear Left speaker (-)
7 Rear Right speaker (-)
8 Rear Right speaker (+)
9 Subwoofer (+)
10 Subwoofer (-)
Connecting the speakers and subwoofer
Class 2 Wiring
To connect your own speaker cable or to connect the
optional adaptor, insert the 10-pin connector into the
appropriate connector. Route the wires through the
molded strain relief channel as illustrated.
138 510 27 49 6
Caution: The in.stream 2 does not come with
speakers and associated wiring. The intercon-
nection between the audio system and the
speakers must be "Class 2 Wiring" and be done
by qualified personnel.
To Next Page
Loading...