2
Y Series TechBook
WARNINGS:
Before installing or connecting the unit, please read the following
* FOR UNITS FOR USE IN OTHER THAN SINGLE-FAMILY DWELLINGS, A CLEARLY LABELED
EMERGENCY SWITCH SHALL BE PROVIDED AS PART OF THE INSTALLATION THE SWITCH SHALL
BE READILY ACCESSIBLE TO THE OCCUPANTS AND SHALL BE INSTALLED AT LEAST 5' (152 M) AWAY,
ADJACENT TO, AND WITHIN SIGHT OF THE UNIT
* ANY DAMAGED CABLE MUST BE IMMEDIATELY REPLACED
* TURN POWER OFF BEFORE SERVICING OR MODIFYING ANY CABLE CONNECTIONS IN THIS UNIT
* TO PREVENT ELECTRIC SHOCK HAZARD AND/OR WATER DAMAGE TO THIS CONTROL,
ALL UNUSED BUSHING CONDUITS MUST BE PLUGGED WITH THE ATTACHED NIPPLE
* THIS CONTROLLER MUST NOT BE INSTALLED IN PROXIMITY OF HIGHLY FLAMMABLE MATERIALS
* LOW SUPPLY VOLTAGE OR IMPROPER WIRING MAY CAUSE DAMAGE TO THIS CONTROL SYSTEM
READ AND FOLLOW ALL WIRING INSTRUCTIONS WHEN CONNECTING TO POWER SUPPLY
* THIS PACK CONTAINS NO USER SERVICEABLE PARTS CONTACT AN AUTHORIZED SERVICE
CENTER FOR SERVICE
* ALL CONNECTIONS MUST BE MADE BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH
THE NATIONAL ELECTRICAL CODE AND ANY STATE, PROVINCIAL OR LOCAL ELECTRICAL CODE
IN EFFECT AT THE TIME OF THE INSTALLATION
* PRODUCT MUST BE DISPOSED OF SEPARATELY IN ACCORDANCE WITH LOCAL WASTE DISPOSAL
LEGISLATION
Aeware®, Gecko®, and their respective logos are Registered Trademarks of Gecko Alliance Group
Inyt™, inye™, inkeys™, intouch™, ink200™, in.k400™, in.k450™, in.k600™, in.k19™, in.k35™,
in.k8™, in.k800™, ino™, input™, inseal™, inlink™, intcip™, instik™, heatwav™, Y Series™, and their
respective logos are Trademarks of Gecko Alliance Group
All other product or company names that may be mentioned in this publication are tradenames,
trademarks or registered trademarks of their respective owners
Warnings
To Next Page
Loading...
Need help?
General
