Geco GC201 - Table of Contents

page 2 SERVICE MANUAL FOR PRODUCERS SBR TYPE GC201
PPUH „GECO” EDITION I PRINTOUT DATE 18-04-30
Table of contents
I. GENERAL CHARACTERISTICS. ................................................................................. 3
II. METHOD OF MARKING AND TECHNICAL DATA ...................................................... 3
III. HOW TO ORDER..................................................................................................... 4
IV. INSTALLATION AND CONNECTION OF GC201 ...................................................... 5
V. INSTALLATION OF SENSORS. .................................................................................. 6
VI. OPERATION METHOD ......................................................................................... 6
A - GENERAL INFORMATION ................................................................................................. 6
1. Start after connection to mains .............................................................................. 6
2. Functions of buttons ............................................................................................... 7
3. Programming of temperature: ............................................................................... 7
4. Signalling of compressor operation ........................................................................ 7
5. Compressor protection ........................................................................................... 8
6. Alarms of sensors – A1 and A2 ............................................................................... 8
7. Overheating alarm - A4 .......................................................................................... 8
8. Temperature monitoring ........................................................................................ 8
B - DEFROSTING ................................................................................................................ 9
C – SUPER FROST ............................................................................................................... 9
D – HYSTERESIS ............................................................................................................... 10
VII. PROGRAMMING OF SYSTEM PARAMETERS ...................................................... 12
VIII. PROBLEMS AND THEIR REMOVAL ..................................................................... 14
IX. RETURNS FOR REPAIR .......................................................................................... 16
X. METHOD OF CONNECTING DEVICES TO THE CONTROLLER ................................... 16
XI. INFORMATION ABOUT MARKING AND COLLECTION OF USED ELECTRICAL AND
ELECTRONIC EQUIPMENT .......................................................................................... 20