Scissors FaucetWrench for
Membrane Housing
Tools Needed
Do not use for the treatment of water that is visually contaminated(cloudy) or
has an obvious contamination source, such as contamination by raw sewage.
All plumbing should be done in accordance with local codes and requirements.
Non-Booster pump models work on inlet water pressures of 40 psi (minimum) to
100 psi (maximum).If your house water pressure is over the maximum, install a
pressure reducing valve in the water supply line to the filter system.
Do not install the system outside, or in extreme hot or cold temperatures.
Temperature of the water supply to the R/O system must be between 40-110°F
/5-45°C.Do not install on hot water.
Plastic Tube Cutter 3/8" Variable Speed Electric
Drill; 1/8",1/4",1/2" Bits
Teflon Tape
Center Punch and
Hammer
Monkey Wrench Faucet Bracket
3
To Next Page
Loading...