Dip-switch and Jumper
S6 - S7 Selection of the AC mains frequency: 50 or 60 Hz
Control description
OK RELAY
The OK relay has a normally open contact which close at the end of the precharging phase if no alarm condition is present
(overtemperature, power supply on the regulation card ±15V).
The contact is closed during the normal functioning of the device and also during an undervoltage situation. The contact
opens when a failure occurs (see the alarm conditions described above) or when the power supply is switched off and the DC-
LINK is completely discharged (C and D terminals).
Addendum to the ADV200 / ADV200WA QS Instruction books Page 11 of 20
To Next Page
Loading...
