SL5625 - DECALS
907221/BP0698
2
PRINTED IN U.S.A.
Decal Application
CAUTION
ALWAYS read and abide by the safety rules
and information shown on the decals. If
decals become damaged, unreadable or if
the unit is repainted, the decals MUST be
replaced. If repainting, make sure all decals
which apply to the machine are properly
affixed to the unit in their proper location.
Decal location information is provided to assist in the
proper selection and application of new decals in the
event of the original decals become damaged or the
machine is repainted.
For correct replacement of decals, compare the close-up
location photographs to your machine before starting to
refinish the unit. Check off each required decal using the
illustration reference number to find the part number,
description, and quantity in the list. Refer to the appro-
priate illustrations for replacement locations.
NOTE:
Refer to the SAFETY chapter of the
Operator’s Manual for the specific information
provided on all of the various Safety Decals.
Before applying decals, surfaces must be free from dirt,
dust, grease, and other foreign material. To apply a
decal, remove the smaller portion of the decal backing
paper and apply exposed adhesive backing to the clean
surface while maintaining proper position and alignment.
Slowly peel off the other backing paper while applying
hand pressure to smooth out the decal surface.
Paint Finish - SN 8468 and later
Use the following chart to order paint for refinishing.
Number Quantity Product
906213 1 gallon Construction Yellow
906323 1 quart Charcoal Gray
906317 1 gallon Charcoal Gray
906214 6 - 12 oz Spray Cans Construction Yellow
906318 6 - 12 oz Spray Cans Charcoal Gray
Paint Finish - Before SN 8468
Use the following chart to order paint for refinishing.
Number Quantity Product
903892 1 gallon Industrial Yellow
902873 1 gallon Black
903891 6 - 12 oz Spray Cans Industrial Yellow
902875 6 - 12 oz Spray Cans Black
Decals
NOTES
To Next Page
Loading...
Need help?
General
