GEL DECAL - Water Sentinel System: Setting OFF; Water Sentinel System: Setting ON

78
From the programming display, move the selection on “AntiFlood” with keys
- Press key to come back to the previous selection, or
- Press key
to confirm the setting
- press keys either to deactivate (= OFF) or activate (= ON) the device Water Sentinel.
13.11 - WATER SENTINEL IN POSITION = OFF (reserved to Technical Assistance Service)
- Press key to come back to the previous display, or
- Press key
to confirm the setting
the display below will be shown
In this display it is not possible to modify any data; press key to come back to the previous display,
or press key
to confirm the setting.
13.12 - WATER SENTINEL IN POSITION = ON (reserved to Technical Assistance Service)
- Press key
to come back to the previous display, or
- Press key
to confirm the setting
the display below will be shown
- press keys to change the leakage reading time – MAXIMUM TAKING (from 5 to 90
minutes; default value = 20 minutes) of the anti-flood system. The system will
block the water entry when it reads a continuous flow for a time longer than the one set.
- Press key
to confirm the setting.
ANTI-FLOOD SYSTEM
STATUS = ON
TO CHANGE PRESS
+
or –
TO CONFIRM PRESS B
21
22
23
ANTI-FLOOD SYSTEM
MAXIMUM WATER TAKING = Min
TO CHANGE PRESS
+
or –
TO CONFIRM PRESS B
ANTI-FLOOD SYSTEM
MAXIMUM WATER TAKING = 30 Min
TO CHANGE PRESS
+
or –
TO CONFIRM PRESS B