27
the “X2” Position and pressing the
Z1 Position and Z2 Position
There are two types of reports that can be taken in the "Z" position
"Z1"- Commonly known as an "end-of-day" reading. This prints transaction data and
resets all transaction totals to zero except the non-resettable ground total (NRGT).
The machine will, however, still accumulate totals in memory until a "Z2" report is
taken. The “Z1” Report can be taken by turning the Key to the “Z1” Position and
pressing
"Z2" - Commonly known as a "weekly" or "monthly" reading. This prints transaction
data either on a weekly or monthly basis and resets all transaction totals to zero
except the Non-resettable ground total (NRGT). The “Z2” Report can be taken
simply by turning the Key to the “Z2” Position and pressing
NOTE: If you do not have a pre-programmed Full Report button on your Keyboard
then this report can also be taken by turning the Key to the relevant reporting
position and pressing the Enter Key 3 times.
X 3
To Next Page
Loading...
