www.gemu-group.com52 / 76GEMÜ 1436 cPos
16 Operation
Service
1
Return
Code: 0
Active Level: 3
(0...10000)
Logout?
OK
NewCode:1 1
0...10000
NewCode:2 2
0...10000
NewCode:3 3
0...10000
Login
1.2
r1w1 r1w1 r2w2 r3w3
I/O Status
1.1
Code:
Enter code for user access. The currently released user level is displayed at Active Level.
Example:
In Active Level 0 the positioner is disabled in all three user levels.
Only the parameters marked by the symbol r0w0 can be read and changed.
Logout:
Serves to log out of write protected and read protected areas in the menu. This function disables various menus depending on
the user level activated.
User level 0 is displayed in parameter Active Level.
NewCode1:
Enter the new code for the lowest user level (user level 1) (default setting 0).
NewCode2:
Enter the new code for the medium user level (user level 2) (default setting 0).
NewCode3:
Enter the new code for the highest user level (user level 3) (default setting 0).
NOTICE
▶ Factory setting 0 means that all three codes are assigned 0. This means that all parameter menus are released.
Example:
If user level 2 is to be disabled, user level 2 and also user level 3 must be assigned a code.
NOTICE
▶ During activation or deactivation of the user levels via the RS232-interface, other codes can be assigned in the same way as
the direct input of codes via the product keypad.
▶ This ensures specific disabling of the use of the positioner either directly via the positioner or via the RS232-interface de-
pending on the type of operation.
The codes for operation via the RS232-interface can only be assigned, activated or deactivated via the RS232-interface. The
codes for direct operation via the product keypad can only be assigned, activated or deactivated via the keypad on the device it-
self.
16.2.3.5.1.3 Reading out, deleting and deactivating error messages
Service
1
SetBasics
2
SetFunction
3
SetCalibration
4
Return
6
SETUP
Communication
5
I / O Status
1.1
Login
1.2
Diagnosis
1.3
Error List:
To Next Page
Loading...
Need help?
General