4
Playing the RP60/70
Turn the instrument on
1. To turn the RP60/70 on, press the ON/OFF switch located on the left
key block.
After a short period, the instrument is ready to play the Grand Piano
preset. The LED of the Grand Piano Preset button will be on as an
indication that the instrument is on.
In this power up condition, you will be able to play a piano sound
(GrandPiano) across the entire keyboard without carrying out other
operations.
Adjust the overall volume
2. Use the VOLUME control knob to adjust the overall volume level.
Clockwise rotation of the VOLUME control knob increases the overall
volume and counter-clockwise rotation decreases it.
Headphone jacks
The headphone jacks are located at the extreme left side of the rail which runs
beneath the keyboard.
Plugging a set of headphones into the left jack excludes the internal speakers
to allow you to play in total silence without disturbing others in the same room.
Plugging into the right jack does not exclude the internal speakers.
Use the Volume control on the left key block to adjust the Headphones volume.
Pedal Connection
The RP60/70 is supplied with a twin pedal assembly, consisting of the Soft and
Damper pedals. Make sure that the cable from the pedal assembly is
connected to the Pedals connector on the rear connections panel.
Soft: The Soft pedal (left) is a switch control pedal (On/Off) which
affects the timbre of the instrument such that it plays softer, allowing you
to continue using the same playing style at a lower volume.
Damper: The Damper pedal (right) applies the Sustain effect to all
notes released. If you release a note after depressing the Damper, the
note will proceed towards its natural decay according to the type of
sound played. The Damper is particularly effective with Piano type
sounds.
Listen to the Demo song
The RP60/70 contains a demonstration recording of the internal sounds.
1 Press both the DATA m and n buttons at the same time.
The Demo song will start to play instantly. When it reaches the end, it
will start from the beginning and repeats continually until stopped.
2 To stop the playback at any point, press both DATA m/n buttons at the
same time.
You can also use the Grand Piano Preset button to stop the Demo.
LED on
SOFT
DAMPER