Rev. 00 12/23
OptiSpray AP02 Product description • 9
Product description
Intended use
The application pump is intended for conveying coating powder to the
spray gun (see also in the "Technical data” chapter).
The application pump operates only in combination with the OptiStar
CG24-CP or CG12-CP control unit (automatic equipment) or the OptiStar
CG23-P or CG11-P control unit (manual equipment).
The application pump will only operate in combination with the OptiGun
GA04-P automatic gun or with other Gema models with a suitable diffuser
(spraying air adapter). Please contact Gema if you have any further
queries.
Fig. 1
Observance of the operating, service and maintenance instructions
specified by the manufacturer is also part of the intended use. This
product should only be used, maintained and started up by trained
personnel, who are informed about and are familiar with the possible
hazards involved.
Any other use is not considered as intended use. The manufacturer is not
responsible for any incorrect use and the risks associated with such
actions are assumed by the user alone!
For a better understanding of the interrelationships in powder coating, it is
recommended that the operating instructions for all other components be
read as well, so as to be familiar with their functions too.
To Next Page
Loading...
