Gemalto AT10Ki User Manual

Intelligent Document Reader AT10Ki User Guide Reader components
Page 18 of 41
Power Supply
A power supply is included with each Gemalto Intelligent Document Reader AT10Ki which is CB scheme
Listed LPS and capable of providing +5V DC at 3A.
Gemalto recommends the use of the supplied power supply for best performance and compliance to
regulations.
To reduce the risk associated with hazardous voltage which, if not avoided, could result in death or
serious injury:
 Do not use the reader with any AC power supply other than the provided Gemalto AC power
supply.
 Do not use AC power supply and/or power cord if damaged.
 Do not open the reader and/or power supply. Reader is to be serviced by trained personnel
only. No user serviceable parts or adjustments inside.
 Do not modify or attempt to modify the reader and/or AC power supply.
 Use only in an indoor dry location. Do not use the product in an outdoor and/or wet environment.
Modifications or changes to the Product, the interface cables or the power supply not expressly
approved by the manufacturer could void the User's authority to operate the Product and/or break
local laws or regulations.
Alternative Power Options
The Gemalto Intelligent Document Reader AT10Ki can be powered from either a USB port or from a
Power Over Ethernet network connection. Each of these has different capabilities summed in the table
below:
Operational mode
Auxiliary
ports
powered?
OS
Can power source be used?
USB2
500mA
USB3
900mA
USB3
1.5A
POE
PSU
Legacy USB
No
Windows
No
No
Yes
No
Yes
Legacy USB
Yes
Windows
Yes
Yes
Yes
No
Yes
Legacy USB with ARM running
Either
Windows
No
No
Yes
No
Yes
Legacy USB
No
Mac/Linux
No
No
Yes
No
Yes
Legacy USB
Yes
Mac/Linux
No
Yes
Yes
No
Yes
Legacy USB with ARM running
Either
Mac/Linux
No
No
Yes
No
Yes
Ethernet
Either
Any
No
No
No
Yes
Yes
WiFi and Bluetooth
Either
Any
No
No
No
Yes
Yes

Gemalto AT10Ki Specifications

General

Brand	Gemalto
Model	AT10Ki
Category	Card Reader
Language	English