EasyManuals Logo

Gemini GEM-P3200 User Manual

Gemini GEM-P3200
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
X
GEM-P3200 Programming Instructions
L
NAPCO Security Systems
WI818D 08/00
!
Page 70
KEYPAD CONFIGURATION MODE
GEM-RP1CAe2
KEYPADS
Press
A
button
Enter Factory Code:
11123
Configure:
Keypad Beep ON/OFF
Entry Sounder
Keypad Address 01
New Compat# 000 **
EZM Address 00
Zone Response 00
Program Control Message# 1
Press
C
button
(“
01 OUT OF SYSTEM
”)
Return Jumper JP5 * from Pins 2-3 to Pins 1-2
(“
SYSTEM READY
”)
Move Jumper JP5 * from Pins 1-2 to Pins 2-3
(Wait about 15 seconds: “
OUT OF SYSTEM
”)
Configure:
Keypad Address (Jumpers J1-J3)
Touchpad Backlight (Jumper A)
LCD Backlight (Jumper B)
Entry Sounder (Jumper C)
GEM-RP2ASe2
KEYPADS
* JP5 is located at the top-right corner of the circuit board.
** If a Compatibility Number other than “0000” is programmed,
OLD COMPAT# XXXX
” is displayed.
Keypad Programming Modes: Keypad Configuration Mode
GEM-RP3DGTL
KEYPADS
Configure:
Keypad Address (Jumpers J1-J3)
Touchpad Backlight (Jumper A)
Entry Sounder (Jumper C)
Enable Tamper LED (Jumper E)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gemini GEM-P3200 and is the answer not in the manual?

Gemini GEM-P3200 Specifications

General IconGeneral
BrandGemini
ModelGEM-P3200
CategoryControl Panel
LanguageEnglish