15
to gently depress the spring loaded
probe tip slightly inside the housing.
Then carefully rub the probe tip in
one direction on the paper to clean it.
11. Using the Optional UltraDock 3: Place
the charging station in a convenient
location near where it will be used
such as on a desk, showcase or
repair area. Take the testers micro-
USB power cord and plug it into
the rear of the UltraDock 3, while
plugging the USB into its AC power
cube adapter. Plug the adapter into
a convenient wall outlet. You may
now simply place the PRO-D 3 in the
charging stations cradle with its on
bottom edge facing down, and the
rear of the PRO-D 3 facing the back
end of the cradle. The PRO-D 3 will
automatically have its NiMH batteries
charged while in the UltraDock 3.
(see image)
TESTER IN OPTIONAL ULTRADOCK 3
To Next Page
Loading...
