GEMORO TESTEROSSA 20 21
11. Testing Loose Stones: Place
the loose stone in the supplied
aluminum loose stone testing plate
positioned with the stones culet
pointing down into the recessed
hole part of the testing plate. Then
hold the testing plate steady with
one hand, as this will also allow
the electrical current to pass
through your body, permitting the
tester to function as designed and
test properly. While holding the
TESTEROSSA in your other hand,
firmly touch the probe tip to the
loose stone’s table until the test
result it indicated
N
. YOU MUST
FOLLOW THIS PROCEDURE
WHEN TESTING LOOSE STONES
OR THE TESTER MAY NOT TEST
CORRECTLY. DO NOT ATTEMPT
TO TEST LOOSE STONES
WHILE HOLDING THEM IN
YOUR FINGERS OR THE TESTER
MAY NOT TEST CORRECTLY.
12. The probe tip must be cleaned
routinely to ensure proper contact
with the stone being tested. To
clean the tip, take a piece of
uncoated white printer or copy
paper and lay it on a table or
counter or other flat surface.
Place the tester in a 90-degree
angle against the paper with
the probe tip lightly touching it.
Apply enough pressure to gently
depress the retractable probe tip
slightly inside the housing while
carefully rubbing the probe tip
on the paper in a forward motion
a few times to clean it. Repeat
this process routinely or prior to
testing each time to ensure the
cleanliness of the probe tip.
13. Using the UltraDock 3: Place the
charging station in a convenient
location near where it will be used,
such as on a desk, showcase or
repair area counter. Take the testers
micro-USB power cord and plug
it into the rear of the UltraDock
3, while plugging the USB into its
AC power cube adapter. Plug the
adapter into a convenient wall
outlet. When the charging station
is plugged in and has power, the
diamond shaped indicator on the
front end of the dock will remain
glowing green. You may now
simply place the TESTEROSSA in
the charging stations cradle with
its bottom edge facing down, and
the rear of the TESTEROSSA facing
the back end of the cradle. When
placed in the cradle, always confirm
the tester is properly seated in
the UltraDock 3 and is charging,
as indicated by the round LED
indicator on the TESTEROSSA next
to the testers power button glowing
either yellow for charging batteries
or green for fully charged batteries.
The TESTEROSSA will automatically
have its NiMH batteries charged
while in the UltraDock 3
O
.
TESTING LOOSE STONES WITH
TESTING PLATE
N
To Next Page
Loading...
