GEMORO TESTEROSSA 12 13
12. Round LED indicator
E
RED = Low Batteries
YELLOW = Charging Batteries
GREEN = Fully Charged Batteries
13. Bright blue LED illuminated
power button.
14. Pocket-sized and portable.
15. Simple to operate.
SPECIFICATIONS
• Working Voltage: DC 1.2V (3) x AAA
NiMH, DC 1.5V, (3) x AAA alkaline
batteries or its universal voltage
100V-240V AC adapter cube.
• Probe Tip Warm-Up Time:
Approximately 25 seconds.
• Auto-Off Time: Approximately
5 minutes of non-use.
• NiMH and Alkaline Battery
Working Time: Approximately
two hours of continuous use.
• Working Temperature:
65°F-80°F (18°C-27°C).
• Air Relative Humidity: 45%-75%.
• Net Weight: Approximately
100g (including batteries).
CAUTION:
• DO NOT disassemble the
TESTEROSSA other than to
replace the batteries or the
warranty will become void.
• UV EYE HAZARD - Avoid looking
directly into the UV LED.
OPERATION
1. NiMH Battery Usage and Alkaline
Battery Installation: To activate
the (3) NiMH rechargeable
batteries, REMOVE THE BATTERY
DISCHARGE INSULATOR TAB
F
that is extending out of the
battery compartment by simply
pulling it out. To increase the
life of the NiMH rechargeable
batteries, after removing the
discharge insulator tab in the
battery compartment, fully charge
the batteries prior to use.
If you wish to replace the NiMH
batteries with alkaline batteries,
remove the battery compartment
door located on the end of the
TESTEROSSA by using your thumb
to slide the textured area down and
in the direction of the arrow
G
Remove the NiMH rechargeable
batteries while making note
of the polarity positioning on
batteries. Then insert (3) high-
quality AAA 1.5V alkaline batteries
into the battery compartment.
The proper polarity positioning
is indicated on the side of the
BATTERY DISCHARGE INSULATOR TAB
BATTERY LED INDICATOR
E
F
To Next Page
Loading...
