GEMORO TESTEROSSA 8 9
via its PATENTED color-coded
light pipe and simultaneously
it is also spoken verbally in one
of nine different PATENTED
user-programmable languages
(English, Spanish, German, Italian,
French, Japanese, Mandarin
Chinese, Russian, and Arabic).
Instead of talking, alternatively
the tester may be programmed
to provide unique PATENTED
ring tones when identifying the
various materials or other alerts.
2. Quickly assists with testing
most any size diamond and
moissanite, including the new
most difficult to identify, super-
low electrically conductivity
Forever One moissanite,
whether mounted or loose.
3. The sleek and ergonomic shape
comfortably rests in and on your
hand when held, and the tester
has PATENTED intuitive finger
grip pads for increased user-
friendliness and ease of handling.
4. The LED illuminator and UV
fluorescence detector are
positioned under the probe tip.
The LED Illuminator is a super
bright LED that illuminates the
stone being tested and, since it is
a UV LED, it also helps to identify
fluorescence in diamonds.
5. The tester is equipped with a
retractable probe tip designed to
protect the probe tip if excessive
force is used while testing or
if it is accidentally dropped.
6. The tester housing is made
from virtually indestructible
polycarbonate, and has a
molded rubber base for
increased impact resistance.
4. It is imperative that the probe
tip be cleaned regularly or ideally
prior to performing a test. Please
be aware that there may be hand,
body oil or other contaminates
that may not be visible on the
probe tip, which could impact
the accuracy of the test. To clean
the tip, take a piece of uncoated
white printer or copy paper and
lay it on a table, counter or other
flat surface. Place the tester at a
90-degree angle against the paper
with the probe tip lightly touching
it. Apply enough pressure to gently
depress the retractable probe tip
slightly inside the housing while
carefully rubbing the probe tip
on the paper in a forward motion
a few times to clean it. Repeat
this process routinely or prior to
testing each time to ensure the
cleanliness of the probe tip.
5. Always allow the stone being
tested to cool off for 5-10 seconds
prior to retesting. Blowing on the
stone is recommended and will
speed up this process. Please be
aware that if while testing a stone
the TESTEROSSA’s light pipe turns
pink, unless it is a white sapphire
or sapphire watch crystal, odds are
that the stone has been overheated
from prolonged exposure to the
probe tip and, therefore, you must
wait for the stone to cool off for
a few seconds prior to retesting.
TESTEROSSA FEATURES
1. Helps to identify diamond,
moissanite, and white sapphire,
including genuine sapphire watch
crystals. The test results are shown
To Next Page
Loading...
