System Setup (cont.):
Other Cymbals:
Remove your existing cymbal felts and cymbal sleeve. Slide a Gen16 cymbal sleeve onto your cymbal
stand and place the pickup over the sleeve. Place a Gen16 foam washer over the pickup, place your
AE Cymbal on the washer, place another Gen16 foam washer over the cymbal, and secure with the supplied
stabilizing washer.
Note: Gen16 cymbal sleeves and foam washers have been specially designed and made from special
materials to provide optimum results with your AE Cymbals. We strongly encourage you to use only Gen16
mounting accessories; use of generic sleeves and washers can result in undesirable stand vibration bleed-
through and excessive cymbal “ringing” overtones.
13
To Next Page
Loading...