Gen16 AE - System Operation: Channel Solo Mode

To Next Page

To Previous Page

System Operation (cont.):

Channel Solo Mode:

Channel solo mode provides a quick way to listen to only one cymbal channel while muting all the others. This

can be useful for tracking down which cymbal might be feeding back or for just “zoning in” on one cymbal to ad-

just its sound. Channel Solo can also be used as a “Panic Button” to mute all channels in the event of feedback.

To enter Channel Solo mode, press and hold Cym3. When Channel Solo mode is ﬁrst entered, all ﬁve cymbal

channels will be muted - each channel’s preset number display will show “- -“ to indicate its muted status. (The

volume control knob for muted channels is also disabled in solo mode.) To solo a channel, press its or

button. Its preset number will be displayed, ﬂashing, to indicate that it is being soloed, and its volume control

will be enabled. While soloed, a channel’s preset may be changed if desired. To solo another channel, simply

press its or button.

To exit Solo mode, press and hold Cym3.

Note: Even though the Volume controls of muted channels are disabled in Solo Mode, once Solo Mode is

exited they will immediately become active again, and all channel volumes will return to the levels set by their

Volume controls. For this reason, it is not advisable to change the Volume position of a muted channel.

PRESET