Gen16 AE - System Operation: Basic Functions

To Next Page

To Previous Page

System Operation:

CAUTION: The Digital Cymbal Processor’s headphone ampliﬁer is capable of driving many headphones

to very high sound levels. Use care in setting the headphone volume level control to avoid potential

hearing damage.

After connecting the system, begin by setting headphone and Master Volume levels to minimum before power-

ing on the Digital Cymbal Processor. For best noise performance, cymbal volume controls should generally be

around the “12:00” position or higher. Turn your PA volume down, then switch the DCP into its “On” or “On with

Pickup Lights” position. Gradually raise output volumes to a comfortable level, ﬁrst the DCP, then the PA.

Basic Functions:

Changing Cymbal Presets:

To change a channel’s preset, press its or button. Preset values range from 1 to the number of stored

presets for each cymbal.

Changing the Reverb Preset:

To change the reverb preset, press and hold Ride and simultaneously to enter reverb preset selection

mode. The top two display digits will show the current reverb preset. Press Hi-Hat or to scroll through

the reverb presets. Press Ride and simultaneously again to exit reverb selection mode.

PRESET