Gen3 Verve - How to Ride Your Scooter; Riding Preparation and Starting; Braking, Steering, and Turning

The Verve:
• Level 1 ( ): 6.2 mp/h (10 km/h)
• Level 2 ( ): 9.3 mp/h (15 km/h)
• Level 3 ( ): 15.5 mp/h (25 km/h)
• Walk Assist ( ): 3.1 mp/h
(5 km/h) while walking
beside scooter.
STEP 4 - STARTING ACCELERATION
When the scooter starts to coast, put both feet on
the deck and press the accelerator until it engages .
NOTE: the accelerator initiates once the coasting
speed exceeds 3.1 mph (5 km/h).
STEP 5 - BRAKING
Release the throttle and the scooter will begin
to slow down. Squeeze the brake lever and lean
back to stop.
STEP 6 - STEERING AND TURNING
Tilt your body to the steering direction as you
turn, and slowly turn the handlebar.
STEP 1 - WEAR PROTECTIVE GEAR / POWER ON
THE SCOOTER
Always wear a helmet and knee pads to protect
against injury in case of a falls.
Turn on the scooter, and check the battery
indicator to be sure it is fully charged.
STEP 2 - PUSH TO GET STARTED
Step on the deck with one foot, and slowly
push forward with the foot on the ground.
HOW TO RIDE YOUR SCOOTER
The Verve Pro:
• Level 1 ( ): 6.2 mp/h (10 km/h)
• Level 2 ( ): 12.4 mp/h (20 km/h)
• Level 3 ( ): 1 8.6 mp/h (30 km/h)
• Walk Assist ( ): 3.1 mp/h
(5 km/h) while walking
beside scooter.
STEP 3 - SETTING BOOST LEVEL OR WALK ASSIST MODE
Tap power button to cycle through/select power level:
10