EasyManua.ls Logo

Gen3 Verve - Local Laws and Regulations; Brakes and Quick Release Checks

Gen3 Verve
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Respect pedestrians’ Right of Way. When you ride from behind pedestrians, ring the bell and use your voice to gain attention and slow
your scooter to pass on their left. Travel at a reduced speed or consider walking scooter.
Failure to properly charge, store, or use your battery will void the warranty and may cause a hazardous situation.
Failure to perform and confirm proper installation, compatibility, proper operation, or maintenance of any component or accessory
can result in serious injury or death.
This product is not intended for use at elevations greater than 6562 ft. / 2000 m.
LOCAL LAWS
Regulations related to the use and operation of electric scooters vary based on the country, state/province, county and municipality in
which the rider may live. In many cases, the regulations for the use of an electric scooter are the same as those for a standard bicycle.
However, each jurisdiction may have laws regarding licenses and regulations of electric scooters, where you can ride, minimum rider age,
or required equipment, such as helmets. It is the rider’s responsibility to know the local regulations that apply to an electric scooter and to
obey them.
BRAKES
Make sure the brakes are working with proper stopping power. The levers should stop short of touching the handlebar. Riding with
improperly adjusted or worn brakes is dangerous and can result in injury or death. Replace worn brakes with authorized replacements.
QUICK RELEASE AND FASTENERS
It is important to check the quick release that keeps the folding mechanism in place is properly closed and tightened. Achieving correct
tightening force is vital. Using too little force may result in the fastener not holding securely, while too much force may cause the fastener
to strip threads, deform, or break. Incorrect tightening may result in component failure and cause loss of control and/or accidents. If you
have any questions, please visit a reputable repair shop for assistance.
SAVE THESE INSTRUCTIONS
4