Ceph Upgrade
1-3032-0296-EN Rev 0
8.
Level the Ceph arm front to back while
bolting in place (four screws).
NOTE: To facilitate leveling a
nd minimize
later alignment, have an assistant
support the Ceph assembly up and
towards the rear of the Pan while
tightening the mounting bolts.
9.
Load all Ceph weights into same place in
column, one large then both taped packets.
10.
Remove the shipping bolts and
carriage stop bolt after all components
are m
ounted and the weights are
inserted into place.
To Next Page
Loading...
