English 7
Figure 1. Control and connector layout on the rear panel of a G Two.
Tabletop
This switch is recommended to be switched to
“ON” when the loudspeakers are placed on a ta-
ble or similar surface, such that there is a reec-
tive surface between the loudspeaker and the lis-
tener. Such a placement typically causes a boost
at certain bass frequencies, which the “Tabletop”
function is designed to compensate for.
Low Bass
This switch activates a -4 dB lter to the lowest bass
frequencies (65 Hz). This can be used for compen-
sating for heavy and boosted bass in this frequency
range.
LOW BASS -4 dB
LED OFF
LEVEL -10dB
ISS
TABLETOP
BASS -6 dB
GTwo
Active Loudspeaker
ON
OFF
-2 dB
-4 dB
292-8030W
WARNING: ELECTRICSHOCK HAZARD. DO NOT OPEN. DO NOT
SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE
PARTSINSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
USE EARTHED MAINSCONNECTION ONLY.
AVERTISSEMENT: RISQUEDE CHOC ÉLECTRIQUE. NE PA S
OUVRIR. NE PAS EXPOSERÀL'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT ÀL'INTÉRIEUR REMPLAÇABLEPAR L'UTILISATEUR.
ADRESSER TOUTE RÉPARATIONÀUN PERSONNEL QUALIFIÉ.
CET APPAREILDOIT ÊTRE RACCORDÉÀLA TERRE.
LAITEONLIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN
PISTORASIAAN.
APPARATET MÅ TILKOPLES JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG.
MADE IN FINLAND
MAINS INPUT
50/60Hz60W
100-240 V~
292-G2BT
www.genelec.com
SERIAL NUMBER
This device complies with FCC Part15 and Canadian
ICES-003 radio frequency ClassBemission requirements.
Refer to operating manual for full information.
RCA INPUT
REFLEX PORT
TONE CONTROLS
CONNECTOR PANEL
(HORIZONTAL)
Iso-Pod™TABLE
To Next Page
Loading...
Need help?
General
Weight and Dimensions
