Genelec PowerPak - Accessories

24
www.genelec.com
www.genelec.com
Accessories for 8000/8200 series
Floor stand
8000-409B
Floor stand for 8020A-8050A.
H 895-1370mm.
Corresponding 80X0-408 required.
Table stand (17 cm)
8000-406
Table stand for 8020A, 8030A
and 8040A. 8040-408 required
for use with 8040A.
Stand plate for Iso-Pod
8020-408 and 8030-408,
8040-408 and 8050-408
Flush mount kits for 8040A and 8050A
8040-450B and 8050-450B
Truss mount kit
8000-417B
For all 8000 series models. Clamp
for 50 mm tube, length 365 mm.
Floor stand (mic stand)
8000-403
Floor stand for 8020A.
H 870-1565 mm.
Can be used with 8020-408.
Wall mount with T-plate - black
8000-412B
for 8020A and 8030A,
white version available also.
Ceiling mount - black
8030-405-B
Omnimounts available also for bigger models.
Wall mount - black
8030-404-B
Omnimounts available
also for bigger models.
Wall mount - black
8000-401B
for 8040A, white version available also.
Soft carrying bag
80X0-420
8050A bag is for a single loudspeaker,
all others for a pair.
Security wire
8000-418B
Length 420 mm.
For all 8000 series models.
Adapter for 36mm tube
8000-419B
For all 8000 series models, 8040A and 8050A
require also 8040/8050-408 stand plates.
Ceiling mount
8000-415B
For all 8000 series models.
Length 905-1505 mm.
Wall bracket - black and white
8000-410B and 8000-410W
For 8030A, standard on 8020A.
Wall bracket - black and white.
8000-402-B and 8000-402-W
For all 8000 series models.
19” rack mount kit for 8020A
8020-490 (Two units needed for full 19”)