Genelec S30C - Page 4

CROSSOVERCROSSOVER
CROSSOVERCROSSOVER
CROSSOVER
SECTIONSECTION
SECTIONSECTION
SECTION
SYSTEMSYSTEM
SYSTEMSYSTEM
SYSTEM
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS
AMPLIFIERAMPLIFIER
AMPLIFIERAMPLIFIER
AMPLIFIER
SECTIONSECTION
SECTIONSECTION
SECTION
Bass amplifier output power with an 8 Ohm
load:
Short term 120W
Midrange amplifier output power with an 8
Ohm load:
Short term 120W
Treble amplifier output power with an 8 Ohm
load:
Short term 120W
Long term output power is limited by driver
unit protection circuitry.
Slew rate : 80V/µs
Amplifier system distortion at
nominal output:
THD <0.05%
SMPTE-IM <0.05%
CCIF-IM <0.05%
DIM 100 <0.05%
Signal to Noise ratio, referred to full output:
Bass >100 dB
Midrange >100 dB
Treble >100 dB
Mains voltage: 100/200V or 115/230V
Voltage operating range at
230V setting: 207 - 253V (±10%)
Power consumption:
Idle 30W
Full output 200W
Input connector: XLR female pin1 gnd
pin2 +
pin3 -
Input impedance: 10 kOhm
Input level for 100 dB SPL output @1m:
variable from +6 to -6 dBu
Input level for maximum short term output of
111 dB SPL @1m:
variable from +17 to +5 dBu
Subsonic filter below 38 Hz :
18 dB/octave
Ultrasonic filter above 25 kHz:
12 db/octave
Crossover frequency:
bass/mid 420 Hz
mid/treble 4 kHz
Crossover acoustical slopes:
18 - 24 dB/octave
Crossover level control operating range in 1
dB steps:
bass from 0 to -6 dB
mid from 0 to -6 dB
treble from 0 to -6 dB
Bass roll-off control in 2 dB steps:
from 0 to -8 dB @42 Hz
Bass tilt control in 2 dB steps:
from 0 to -8 dB @80 Hz
The 'CAL' position is with all tone controls
set to 'off' and input sensitivity control to
maximum.
Genelec Document
BBA10001
(1010-0107-2)
COPYRIGHT GENELEC OY 1998
Lower cut-off frequency, -3 dB: <42 Hz
Upper cut-off frequency, -3 dB: >25 kHz
Free field frequency response
of system: 43 Hz - 25 kHz (±2.5 dB)
Maximum short term sine wave
acoustic output on axis
in half space, averaged from
100 Hz to 3 kHz:
@1m >111 dB SPL
@0.5m >117 dB SPL
Maximum long term RMS acoustic
output in same conditions with IEC-weighted
noise (limited by driver unit protection cir-
cuit):
@1m >102 dB SPL
@0.5m >108 dB SPL
Maximum peak acoustic output
per pair on top of console,
@ 1m from the engineer
with music material: >122 dB
Self generated noise level in
free field @ 1m on axis: <10 dB
(A-weighted)
Harmonic distortion at 90 dB SPL
at 1m on axis:
freq. <200 Hz <2%
freq. >200 Hz <1%
Drivers: Bass 210 mm cone
Midrange 80 mm cone
Treble 9x65 mm ribbon
Weight: 20 kg (44 lb)
Dimensions: Height 495 mm (19
1
/
2
")
Width 320 mm (12
5
/
8
")
Depth 290 mm(11
7
/
16
")
Genelec Oy, Olvitie 5
FIN - 74100 IISALMI, FINLAND
Phone: +358 - 17 - 813 311
Telefax: +358 - 17 - 812 267
E-mail: genelec@genelec.com
Web: http://www.genelec.com
Genelec Inc, 7 Tech Circle
Natick, MA 01760, USA
Phone: +1 - 508/652-0900
Fax: +1 - 508/652-0909
E-mail: genelec@compuserve.com