Generac Portable Products 1900 PSIPressureWasher
SPECIFICATIONS
Outlet Pressure ..... 1900psi
Flow Rate .......... 2.0 gallonsper minute (gpm)
Detergent .......... Use detergent approved for
pressure washers
Water Supply ...... Not to Exceed 100°F
Temperature
Automatic Cool .... Will cyclewhen water
Down System reaches 125°-155°F
ShippingWeight .... 54 Ibs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover itemsthat
havebeen subjected to operator abuseor negligence.To
receive full valuefrom the warranty, the operator must
maintain the pressure washer asinstructedin this manual.
• Some adjustments will need to be made periodically to
properly maintain your pressure washer.
• All maintenance in this manualand the engine owner's
manual should be made at least once eachseason.
• Once a year you should clean or replace the spark plug,
clean or replace the air filter and check the spray gun
and adjustable nozzle extension assemblyfor wear.A
new spark plug and clean air filter assure proper fuel-air
mixture and help your engine run better and last longer.
Pleaserefer to your engine owner's manualfor more
details.
• If equipped with inflatabletires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before Each Use
I. Check engine oil level.
2. Check water inletscreen for damage.
3. Check in-linefilter for damage.
4. Check high pressure hose for leaks.
5. Check chemical injection hose and filter for damage.
6. Check spray gun and adjustable nozzle extension
assemblyfor leaks.
7. Rinseout garden hose to flush out debris.
PRESSURE WASH ER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the water inlet.Clean it ifthe
screen isclogged or replace it if screen isdamaged.
Check High Pressure Hose
The high pressure hose can develop leaksfrom wear,
kinking,or abuse.Inspect the hose each time before using
it. Check for cuts,leaks,abrasions or bulging of cover,
damageor movement of couplings.If anyof these
conditions exist, replacethe hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Replacement hose rating MUST exceed maximum pressure
rating of unit.
Check Chemical Injection Hose
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either isdamaged.
Check Gun and Adjustable Nozzle
Extension
Examine the hose connection to the spray gun and make
sure it issecure.Test the trigger by pressingit and making
sure it "springs back" into place when you releaseit. Put
the safety latch in the ON position and test the trigger.You
should not be able to press the trigger.
/
II
To Next Page
Loading...
Need help?
General
