GeneracPortableProducts1900PSIPressureWasher
PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unitfor longperiods of
time. Sedimentsor minerals candeposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days,follow this
procedure:
I. Flushchemical injectionhose by placing filter into a pail
of cleanwater while running pressure washer in low
pressure mode (adjustable nozzle inforward position).
Flushfor one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses.Disconnect spark plug wire
from spark plug.
3. Empty pump of all pumped liquids by pulling recoil
handle about 6 times.This should remove most liquid
in pump.
4. Use PumpSaverto prevent corrosion build up and
freezing of pump.
5. Store unitin a clean,dry area.
Protecting the Pump
To protect the pump from damagecaused by mineral
deposits or freezing,use PumpSaverto treat pump.This
prevents freeze damageand lubricates pistons and seals.
NOTE: PumpSaveris availableas an optional accessory.It
is not included with the pressure washer. Contact the
nearestauthorized service center to purchasePumpSaver.
CAUTION
• Failure to do so will permanently damage your pump and
renderyour unit inoperable.
• Freezedamageis not coveredunderwarranty.
CAUTION
Always wear eye protection when using PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
NOTE: PumpSaver will drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
I
14
To Next Page
Loading...
Need help?
General
