GeneracPortableProducts1900PSIPressureWasher
Add Engine Oil and Fuel
• Placepressure washer on a level surface.
CAUTION
• Refer to engine manual for oil andfuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oll often during engine break-in. Refer to
engine owner's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage,you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
I. Uncoil high pressure hose and attach one end of hose
to baseof spray gun (Figure4).Tighten by hand.
Connect high pressure
hose here
NOTE: Remove and discard all pump shipping caps before
attaching hoses.
2. Attach other end of high pressure hoseto high
pressure outlet on pump (Figure 5).Tighten by hand.
.
Before connecting garden hose to water inlet,inspect
inlet screen (Figure 6). Clean screen ifit contains
debris or haveit replaced if damaged.Refer to the
section "O-Ring Maintenance" ifinlet screen is
damaged.DO NOT RUN PRESSUREWASHERIF
INLET SCREENISDAMAGED.
Inspect inlet
screen, DO NOT
use if damaged;
clean if dirty.
4. Run water through your garden hose for 30 seconds
to cleanout any debris.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°E).
5. Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tighten by hand (Figure 6).
CAUTION
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
6. Turn ON the water and squeezethe trigger on the
gun to purge the pump system of air and impurities.
WARNING
Always wear eye protection when usingthis equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer,be sure you are wearing
adequate eye protection.
/
7
To Next Page
Loading...
Need help?
General
