Generac Power Systems MLTS User Manual

22 Owner’s Manual for Mobile Light Tower
Operation
Prestart Checklist
Before starting the unit, all items in the prestart checklist
must be completed. This checklist applies to both manual
and remote starting of the unit.
 Verify all maintenance procedures are up to date. For
more information, refer to General Maintenance and
Basic Maintenance Schedule.
 Perform a walk-around inspection. Refer to Daily
Walk-Around Inspection.
 The unit must be level.
 The unit must be dry. Inspect for water inside or near
the unit; dry if needed.
 For grounding requirements, follow the National
Electrical Code (NEC), state, and local regulations.
 Verify the control power switch is OFF (O).
 Verify all circuit breakers are OFF (O).
 Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.
 Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.
 Check oil, coolant, and fuel levels. For more
information, refer to General Maintenance.
 Verify battery connections are secure.
 Turn the battery disconnect switch on, if equipped.
 Inspect the engine fan belt tension and condition.
 Inspect the engine fan belt guard.
 Inspect the engine exhaust system for loose or
rusted components.
 Verify all covers are in place and secure.
Starting the Unit
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to purge the fuel lines.
Refer to the engine operator’s manual supplied with the
unit.
1. See Figure 2-12. Verify main circuit breaker and
circuit breaker for lights are OFF (O).
2. See Figure 3-4. Turn engine ignition switch to
GLOW PLUG position and hold for five seconds
(15 seconds maximum).
IMPORTANT NOTE: Do not hold key in GLOW PLUG
position for more than 15 seconds.
Figure 3-4. Activate Glow Plug
3. See Figure 3-5. Turn ignition switch to START
position and hold (10 seconds maximum) until
engine cranks and starts.
IMPORTANT NOTE: Do not crank engine for more
than 10 seconds.
Figure 3-5. Crank Engine
4. See Figure 3-6. Release ignition switch, it will
move to the RUN position.
Figure 3-6. Release Key
(000100a)
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
CAUTION
(000230)
Equipment Damage. Do not continuously crank
engine for more than ten seconds. Doing so will lead
to overdischarge of batteries and starter seizure.
009951
009952
009953

Generac Power Systems MLTS Specifications

General

Brand	Generac Power Systems
Model	MLTS
Category	Lighting Equipment
Language	English