Safety
Installation and User’s Manual for Mobile Link 5
• Before performing any work near the
generator, remove the control panel fuse
and disconnect the black (–) battery cable
to prevent accidental startup. When
disconnecting battery cables, always
remove the black (–) cable first, then
remove the red (+) cable. When
reconnecting the cables, connect the red
(+) cable first, and then black (–) cable.
Electrical Hazards
This product is intended to be installed in
conjunction with an Automatic Standby
Generator. The generator may crank and start
at any time when utility is lost. When this
occurs, load circuits are transferred to the
STANDBY (generator) power source. Before
working on this generator (for inspection,
service or maintenance), to prevent possible
injury, always set the generator to the OFF
mode and remove the 7.5A fuse from the
generator control panel.
• Verify that all appropriate covers, guards
and barriers are in place, secured and/or
locked before operating the generator. If
work must be done around an operating
unit, stand on an insulated, dry surface to
reduce potential shock hazard.
Explosion Hazards
• Verify that no combustible materials are left
in the generator compartment or on or near
the generator as FIRE or EXPLOSION may
result. Keep the area surrounding the
generator clean and free from debris.
• Gaseous fluids, such as natural gas and
liquid propane (LP) gas, are extremely
EXPLOSIVE. Install the fuel supply system
according to applicable fuel-gas codes.
Before placing the home standby electric
system into service, fuel system lines must
be properly purged and leak tested
according to applicable code. Inspect the
fuel system periodically for leaks. No
leakage can be permitted.
(000144)
DANGER
Electrocution. Contact with bare wires,
terminals, and connections while generator
is running will result in death or serious injury.
(000188)
DANGER
Electrocution. Do not wear jewelry while
working on this equipment. Doing so will
result in death or serious injury.
(000104)
DANGER
Electrocution. Water contact with a power
source, if not avoided, will result in death
or serious injury.
Automatic start-up. Disconnect utility power and
render unit inoperable before working on unit.
Failure to do so will result in death or serious injury.
(000191)
DANGER
(000145)
DANGER
Electrocution. In the event of electrical accident,
immediately shut power OFF. Use non-conductive
implements to free victim from live conductor. Apply
first aid and get medical help. Failure to do so will
result in death or serious injury.
(000115)
WARNING
Moving Parts. Do not wear jewelry when
starting or operating this product. Wearing
jewelry while starting or operating this product
could result in death or serious injury.
(000187)
WARNING
Electrocution. Potentially lethal voltages are generated
by this equipment. Render the equipment safe before
attempting repairs or maintenance. Failure to do so
could result in death or serious injury.
(000192)
DANGER
Explosion and fire.Fuel and vapors are extremely
flammable and explosive. No leakage of fuel is
permitted. Keep fire and spark away. Failure to do
so will result in death or serious injury.
(000143)
DANGER
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Store fuel in a well
ventilated area. Keep fire and spark away. Failure
to do so will result in death or serious injury.
WARNING
Explosion and fire risk. Do not smoke near unit.
Keep fire and spark away. Failure to do so could
result in death, serious injury, or property or
equipment damage.
(000282)
To Next Page
Loading...
Need help?
General
