ALTERNATE WIRING WITH WIRETAP
If an empty breaker isn’t available, you can use the provided
wiretaps to connect to an existing breaker. To do this,
remove the existing wire from the 2 pole 15A or 20A circuit
breaker and replace it with the jumper wire provided in the
contents of the box. Then take the wiretap and insert the
jumper wire, the wire from the PWRview, and the original
wire you removed from the breaker. It might take a little force
to ensure the wires are secured into the wiretap all the way.
NOTE: To remove a wire from the
wiretap, simply pull on the wire and twist it.
To Next Page
Loading...
Need help?
General
