Warranty Statement
General Monitors warrants the Model
TA402A to be free from defects in
workmanship or material under normal use
and service within two (2) years from the
date of shipment. General Monitors will
repair or replace without charge any such
equipment found to be defective during the
warranty period. Full determination of the
nature of, and responsibility for, defective or
damaged equipment will be made by
General Monitors’ personnel. Defective or
damaged equipment must be shipped
prepaid to General Monitors’ plant or the
representative from which shipment was
made. In all cases this warranty is limited to
the cost of the equipment supplied by
General Monitors. The customer will
assume all liability for the misuse of this
equipment by its employees or other
personnel. All warranties are contingent
upon proper use in the application for which
the product was intended and do not cover
products which have been modified or
repaired without General Monitors’ approval
or which have been subjected to neglect,
accident, improper installation or
application, or on which the original
identification marks have been removed or
altered. Except for the express warranty
stated above, General Monitors disclaims all
warranties with regard to the products sold,
including all implied warranties of
merchantability and fitness and the express
warranties stated herein are in lieu of all
obligations or liabilities on the part of
General Monitors for damages including,
but not limited to, consequential damages
arising out of/or in connection with the use
or performance of the product.
Warnings
n
All Zero Two Series Modules
contain components which can be
damaged by static electricity.
Special care must be taken when
wiring the system to ensure that
only the connection points are
touched.
n
Unitized Flame Detectors
designed by General Monitors
will work with the Model
TA402A. Any attempt to use a
Field Device that has not been
designed and approved by
General Monitors will void the
warranty.
n SAFETY WARNING:
Installation and Maintenance
must be carried out by suitably
skilled and competent personnel
only.
n
Full backwards compatibility can
be specified at the time of order.
If this configuration is specified,
the rear terminal output
designation will be identical to the
previous generation of Zero Two
Series Modules.
n
This generation of product can be
distinguished from the previous
generation by the lack of a door
on the front panel. Adjustments
are not necessary on the current
generation of this product.
i
To Next Page
Loading...
Need help?
General
