Genesis GCS130 - Operation; Installing the Rip Guide; Starting and Stopping the Saw; Application Techniques

English
13 Amp, 7-1/4" Circular Saw
Operator’s Manual GCS130
INSTALLING THE RIP GUIDE





 
 

 
 

WARNING: To avoid personal injury and damage to the workpiece, extend the
rip guide through all slots on the base.
OPERATION
STARTING AND STOPPING THE SAW
WARNING: Before plugging in the tool, always check to see that the tool is
switched off. Accidently starting the saw could cause personal injury.
To Start the Saw,
NOTE: 
WARNING: The blade coming into contact with the workpiece before reaching
full speed, could cause your saw to KICKBACK towards you resulting in serious
personal injury.
To Stop the Saw, 
NOTE: D
APPLICATION
WARNING:  To make sawing easier and safer, be sure to move the tool forward
in a straight line gently. Forcing or twisting the tool will result in overheating the motor
and dangerous KICKBACK, possibly causing severe personal injury.




 
 
 
 

 
 
 
 
