English
13 Amp, 7-1/4" Circular Saw
Operator’s Manual GCS130
• Do not use tool if switch does not turn it on or off.
.
•
Turn power tool off, and disconnect the plug
.
.
•
Store idle tool out of reach of children and other inexperienced persons.
•
Maintain power tools with care.
•
Use recommended accessories.
•
Keep cutting tools sharp and clean.
.
•
Feed the workpiece in the correct direction and speed.
•
Never leave the tool running unattended, turn the power off.
• Never start the power tool when any rotating component is in contact with
the workpiece.
WARNING: USE OF THIS TOOL CAN GENERATE AND DISBURSE DUST OR
OTHER AIRBORNE PARTICLES, INCLUDING WOOD DUST, CRYSTALLINE SILICA DUST
AND ASBESTOS. Direct particles away from face and body. Always operate tool in a
well-ventilated area and provide for proper dust removal. Use dust collection system
wherever possible. Exposure to the dust may cause serious and permanent respiratory
or other injury, including silicosis (a serious lung disease), cancer, and death. Avoid
breathing the dust, and avoid prolonged contact with the dust. Allowing dust to get into
your mouth or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection appropriate
for dust exposure, and wash exposed areas with soap and water.
SERVICE
Have your power tool serviced by a qualified repair person using only
identical replacement parts
.
•
Service your power tool periodically.
SAVE THESE INSTRUCTIONS
EXTENSION CORDS
Grounded tools require a three wire extension cord.
To Next Page
Loading...
Need help?
General
