Genesis GCS130 - Assembly and Adjustments; Blade Installation; Removing the Blade; Adjusting Depth of Cut

9
English
ASSEMBLY AND ADJUSTMENTS
WARNING: Always be sure that the tool is switched off and unplugged before
adjusting, adding accessories, or checking a function on the tool.
WARNING: 7-1/4” is the maximum blade capacity of your saw. Never use a
blade that is too thick to allow the outer flange washer to fit properly on the spindle. Too
thick a blade will prevent the blade bolt from securing the blade on the spindle. Larger
diameter blades will contact the blade guards. Either situation could result in a serious
accident.
BLADE INSTALLATION ( FIG 2 )
• 
• 
• 

• 
• 

• 
• 
• 

REMOVING THE BLADE
 
 
 
 
 
 
ADJUSTING THE DEPTH OF CUT
 
 
 
 OR
 


 
NOTE: 

BEVEL ANGLE ADJUSTMENT
 
 

 
 

LINE-OF-CUT INDICATORS
 
 
 
 

FIG 2
19
a
13b
13
2