Genesis GMS15LB - Saw Operation and Table Rotation; Starting and Stopping the Miter Saw; Table Hazard Area; Rotating the Miter Table

FIG 11
7
13
14
FIG 12
17
16
FIG 10
English
10" Compound Laser Miter Saw
Operator’s Manual GMS15LB
To unlock the cutting head,




WARNING: Always transport the miter saw in the locked down position, carrying the saw by carrying handle on
the cutting arm. DO NOT lift or carry the miter saw using the switch handle, doing so may cause misalignment of miter
and bevel settings.
STARTING AND STOPPING THE MITER SAW
To start the miter saw
To stop the miter saw


WARNING: After completing a cut, release the switch trigger to activate the electric blade brake. Keep the
cutting head down until the blade comes to a complete stop before raising the cutting head to the upward or starting
position. A rotating saw blade can be dangerous.
WARNING: The torque resulting from electric blade brake activation may loosen the arbor bolt. Occasionally
check the arbor bolt and tighten if necessary.
TABLE HAZARD AREA




WARNING: Keep your hands outside the “Hazard Zone” and out of the path of the saw blade. Use the supplied
work clamp or other clamping means to secure the work piece in place before making a cut with the miter saw.
WARNING:Always be sure the miter saw is disconnected from the power source before making any
adjustments or during set-up prior to cutting. Failure to disconnect or unplug the machine may cause accidental
starting, resulting in serious personal injury.
ROTATING THE MITER TABLE



NOTE: This miter saw comes with 9 positive click stops, 0° for 90° cutting, left 15°, 22.5° , 30°, 45°, right-15°, 22.5°,
30°, 45° for quick setting of common miter cutting angles
CAUTION: Always tighten the miter lock knob to secure the miter table in position before cutting with the miter saw.
POINTER AND SCALE

